Page
V POWER CONTROL BOX
Remove the
Ridge Ryder
V Power Control Box
from the packaging, check that all items
have been supplied ( x
V Power Control Box, x Sticker Sheets, x Owners Manual).
Unscrew the x Philips head screws holding the lid onto the box using a screwdriver.
Ensure all wiring is connected properly and no internal terminal studs are loose.
See wiring diagram below to connect the input cables from the battery to the red and black
busbars.
.
.
.
.
. The input cables from the battery should be run through the provided side grommets in the
Ryder Ridge
V Power Control Box
.
It is recommended that a fuse is installed (not supplied) in the main line within
cm of the
battery connection to prevent any possible damage/electrical faults to the vehicle.
WIRING INSTRUCTIONS
This
Ridge Ryder
V Power Control Box
has pre-built
V control system - ready to install.
TROUBLESHOOTING
• If no power is being received through the
AMP plugs, press the
Amp resettable circuit
breaker switches to reset off and on again.
• If no power is being received through the V or USB sockets, check the fuses in the fuse block for
fault and replace if necessary.
Содержание 629924
Страница 1: ...PLU V POWER CONTROL BOX OWNERS MANUAL ...
