10. ENVIRONMENT
10.1 Decommissioning and removal
Decommissioning and removal is only permitted to approved personnel.
The starting points that follow are possible:
❶ During the work it is necessary to de-energize.
❷ Storage is necessary because of temporary removal.
❸ The product is at the end of the lifespan.
❶
Temporary decommissioning: Work
1.
Refer to §2.2 “Precautions” and “Safety instructions”.
2.
De-energize the product.
3.
Do the work (maintenance, service or such).
4. Energize the product.
5. The temporary decommissioning is completed.
❷
Temporary decommissioning: Product storage
1.
Refer to §2.2 “Precautions” and “Safety instructions”.
2.
Disconnect the product from the electric circuit.
3.
Disconnect the product mechanically from the system and remove the product (usually in
opposite sequence of the installation).
4.
Refer to §2.2 “Transport, storage and packaging” and obey the (applicable) instructions and
conditions.
5. The temporary decommissioning is completed.
Note:
Obey the product manual for a subsequent installation!
❸
Permanent decommissioning: End of lifespan
1.
Refer to §2.2 “Precautions” and “Safety instructions”.
2.
Disconnect the product from the electric circuit.
3.
Disconnect the product mechanically from the system and remove the product (usually in
opposite sequence of the installation).
4.
Make the product unserviceable and make a mark on the product. This prevents that the
product is (accidentally) used again.
5.
The permanent decommissioning is completed. Refer to
§10.2
“
Waste disposal
”.
Make sure that the system is in a stable and mechanically tension-
free condition and loosened parts (or the system) cannot hit
persons! This prevents damage or injury.
Make sure that the system is in a stable and mechanically tension-
free condition and loosened parts (or the system) cannot hit
persons! This prevents damage or injury.
Ridder Drive Systems B.V.
T
+31 (0)341 416 854 -
F
+31 (0)341 416 611 -
I
30
Содержание LogicLink RLL400
Страница 32: ......
