31 May, 1999
SC CODES
6-1
Trouble-
shooting
6. TROUBLESHOOTING
6.1 SC CODES
SC No.
Description
Required Action
2001
Power-on Self-Diagnostics Error
Check the error code using [Service
Menu] – [Diag. Error].
2002
FGATE error
Check any SC errors for the engine.
6.2 ERROR
CODES
Code
Description
Required Action
0201
On-board SDRAM read/verify
failed.
Replace the controller if this error is
frequent.
0301
SDRAM DIMM (option)
read/verify failed.
Replace the SDRAM DIMM if this error
is frequent.
0Fxx
Controller – BiCU interface error.
Check the connectors and cable
connections.
Replace the motherboard, cable, and/or
BiCU.
1101
Data transmission did not finish
within the specified time.
An incompatible loop-back connector is
connected to the parallel port, or the
loop-back connector is not connected.
Use the correct loop-back connector
(P/#: G0219350) before the test.
1102
Data looped back to the controller
is not the same as the data
transmitted.
The loop-back connector may be
defective. Try using another one.
11xx
Centronics parallel interface error.
Replace the controller if this error is
frequent.
1401
The controller NVRAM has a
problem.
1402
NVRAM checksum error or the
battery has run out.
1403
NVRAM write error
1404
NVRAM read error
Replace the NVRAM if this error is
frequent.
1501
RTC error
Replace the controller board if this error
is frequent.
1601
Font ROM error
Replace the controller if this error is
frequent.
1602
The data in the Font ROM is
damaged.
Replace the controller if this error is
frequent.
1Bxx
Option bus A (CN506) error
Check the connection to the optional
component at CN506.
Try replacing the optional NIB or HDD.
1Cxx
Option bus B (CN507) error
Check the connection to the optional
component at CN507.
Try replacing the optional NIB or HDD.
