Ricoh S7 D3DS, Руководство по обслуживанию на месте, Страница: 17 / 23

1.Install
15
guide onto the feed cover.
4. Snap the edge of the guide onto the posts, and then fasten the guide with the screws.
5. At the left rear corner of the ADF, push the harnesses into the cutout.
6. At the front, pull the hinge arm [A] out slightly.
7. Set the lower guide [B].
8. Make sure that three holes [C] across the top are aligned with the frame below.
•
If the holes are not perfectly aligned, or if the guide is “floating” above the holes, make sure the