Ricoh MP7040S Series, Руководство пользователя

Страница: 12 / 30

5
MP 7040S Series
3. Installing the Drive
3.1 Before Installation
Before installing the drive, please note the following points.
z
your will need the following:
•
SCSI interface board and manual (The SCSI interface board is not
included with this product. You need to purchase it separately. Also,
see page 2 in the "System environment" section for a list of recom
mended models.)
•
Computer manual (You need the manual in order to find out loca
tion of the bus slot for installing the SCSI interface board.)
•
A Phillips head screw driver of a suitable size to fit the securing
screws for the drive unit.
z
Turn off all peripheral appliances of the computer, and the computer itself
, and disconnect their power cords from the wall sockets.
z
Discharge any static electricity by touching the computer covers etc.
z
Record the serial number of the drive unit in the box below.
Serial No.
3.2 SCSI ID Settings
Before installation, set SCSI ID on the rear panel. A single SCSI interface can
connect with a maximum of seven peripheral SCSI devices. When using
multiple SCSI devices, a different SCSI must be set for each of them.
If two peripheral devices use the same SCSI ID number, it will cause the
host computer to operate abnormally or fail to start up.
ON (When the jumper is attached)
OFF (When the jumper is removed)
SCSI ID
Terminator
Reserve (Fixed OFF)