1. The Center for Devices and Radiological Health (CDRH) prohibits the repair of laser-based optical
units in the field.
2. The optical housing unit can only be repaired in a factory or at a location with the requisite
equipment.
3. The laser subsystem is replaceable in the field by a qualified Customer Engineer.
4. The laser chassis is not repairable in the field.
5. Customer engineers are therefore directed to return all chassis and laser subsystems to the factory
or service depot when replacement of the optical subsystem is required.
• Use of controls, or adjustment, or performance of procedures other than those specified in this
manual may result in hazardous radiation exposure.
• Turn off the main switch before attempting any of the procedures in the Laser Unit section. Laser
beams can seriously damage your eyes.
Trademarks
• Microsoft
®
, and Windows
®
are registered trademarks of Microsoft Corporation in the United
States and /or other countries.
• PostScript
®
is a registered trademark of Adobe Systems, Incorporated.
• PCL
®
is a registered trademark of Hewlett-Packard Company.
• Ethernet
®
is a registered trademark of Xerox Corporation.
• PowerPC
®
is a registered trademark of International Business Machines Corporation.
• Other product names used herein are for identification purposes only and may be trademarks of
their respective companies. We disclaim any and all rights involved with those marks.
14
Содержание M178-21
