Ricoh G148, Руководство по обслуживанию

Страница: 303 / 537

No. Item What It Initializes
018 SRM System Resource Management settings
019 LCS Setting Log Count Service settings
1. After clearing all settings, make sure that you perform the following settings:
• Do the laser beam pitch adjustment (SP2109). See Section 3 "Laser Beam Pitch Adjustment".
• Referring to the SMC Report, re-enter any values which had been changed from their factory
settings.
• Execute SP3001-2 (ID Sensor Initial Setting).
• Set SP 1902 001 (amount of fusing unit web used so far) to the most recent setting (see the SMC
list).
Test Pattern Printing
Test pattern printing is a two-step operation. First, you must do SP2902 to select the pattern that you want
to print. When you select any pattern other than "0:None" under SP2902, this sets the printer in the Test
Pattern Print mode. Second, you must do SP5990 005 to print the pattern.
• You can select any selection under SP5990 to print the selected pattern. However, SP5990 005
(Diagnostic Report) is recommended because it prints only one page. If you select "001", for example,
several copies of the same pattern may print.
• The printer will remain in the Test Pattern Print mode until you leave the SP mode or the printer is cycled
off and on. (If you leave and re-enter SP mode and turn the printer power off/on, this automatically
reselects "0:None" for SP2902.)
• The normal SMC report lists that are done with SP5990 will not print until the printer has been released
from the Test Pattern Print mode.
Selecting the Test Pattern
Do SP2902 to select the test pattern that you want to print.
1. To enter the SP mode, press

together (5s), release, then press [#Enter].
System Ver.1.00
1. Service
2. Press  .
System Ver. 1.00
2. Engine
3. Press [#Enter].
5. Service Tables
302
5