Ricoh Da-P1, Руководство по обслуживанию на месте

Страница: 172 / 452

Service Call
Summary
Level Definition Reset Procedure
A
To prevent damage to the machine, the main machine
cannot be operated until the SC has been reset by a
service representative (see the note below). Enter SP mode, go into
SP5-810-001, press [Execute],
and turn the main power off/on.
B
SCs that disable only the features that use the defective
item. Although these SCs are not shown to the user
under normal conditions, they are displayed on the
operation panel only when the defective feature is
selected. Turn the main power off/on.
C
The SC history is updated. The machine can be
operated as usual. The SC will not be displayed.
Only the SC history is updated.
D
Turning the main power off then on resets SCs displayed
on the operation panel. These are re-displayed if the
error occurs again. Turn the main power off/on.
When a Level “D” SC code occurs
When a Level D SC occurs, a screen opens on the operation panel to tell the operator:
• An error occurred
• The job in progress will be erased
• The machine will reboot automatically after approximately 30 seconds.
The operator can wait until the machine reboots automatically or touch “Reset” on the screen to reset the
machine immediately and go back to the copy screen.
If the operator does not touch “Reset”
The next message tells the operator that the machine will reset automatically and that the previous
job was lost and must be started again. After reading the message, the operator touches “Confirm”
on the screen. The next screen shows the number and title of the SC code, and stops until the
operator turns the machine off and on.
If the operator touches “Reset”
If the operator touches "Reset" to bypass the 30-second interval for the machine to reboot, the
machine reboots immediately and the operation panel displays the copy screen.
6. Troubleshooting
170