Ricoh D3GF, Руководство по обслуживанию на месте

Страница: 94 / 187

4.System Maintenance
88
Restoring the Default Fiery Settings (Operation Panel)
To restore the default configuration settings of E-25C, use the Factory Defaults feature.
1.
Make sure the E-25C is not in use.
2.
Print a configuration page (you may refer to this configuration page when you re-enter the setup
options). [Link to Printing the Configuration Page or Test Sheets ]
3.
Access the setup menu. [Link to Running the E-25C Setup ]
4.
Touch "Factory Defaults".
5.
When you are prompted "Change all settings (including network) back to Factory Defaults and
Reboot?", touch "Continue".
6.
Wait for the diagnostic LEDs on the E-25C to turn off.
7.
Wait for 10-15 minutes. When the diagnostic LEDs remain at '00', go to the copier operation panel
and press the Home button.

During the 10-15 minutes, the diagnostic LED may remain displaying 'FF' for several
times, but this does not indicate an error.
8.
Touch the Fiery icon. "Please Wait!" may be shown on the copier operation panel for a while.
9.
Within a few minutes, the language selection screen is shown. If this screen is not shown, then
press the Home button on the operation panel of the copier and then touch the Fiery icon again.
Start to configure the E-25C. For details, go to step 29 of the system software installation
procedure. [Link to System Software Installation Procedure ]
For the procedure of operating from the Configure menu, refer to the Configuration and Setup Guide .