Ricoh D3GB, Руководство по обслуживанию на месте

Страница: 62 / 64

2.Replacement and Adjustment
58
6.
Make sure that the paper covers the entire area below the image position sensor (CIS) [C].
7.
Enter the SP mode. Execute SP1910-002 (CIS Image Position Adjustment: LED Strength - LCT).
This calibrates the amount of light to be emitted from the CIS.
8.
Execute SP1909 002 (CIS Image Position Adjustment: PWM After Adjustment - LCT).

If the displayed value is between Ah (10) and 28h (40), the CIS is calibrated successfully. (The
display is in hexadecimal code.)

If the value is outside the above range, execute SP 1910-002 and 1909-002 again. If the value
does not come between Ah and 28h, the CIS may be defective.
9.
Exit the SP mode.
10.
Re-attach the LCT to the main machine.
11.
Select [User Tools]> [Adjust Settings for Operators].
12.
Execute "0111-4 to -7" for Trays 4, 5, 6, 7 and set the value for each tray to "Off".
13.
Exit from [User Tools] > [Adjust Settings for Operators] and return to the SP mode menu.
14.
Adjust the image positions in the main scan direction.

Execute SP2902-003. Select Pattern 27, then print the trimming pattern.

Execute SP1002. Adjust the image position in the main scan direction for Trays 4, 5, 6, and 7.

Print the trimming pattern from each tray of the LCT and from the bypass tray (if installed).

The distance of the test pattern line from the paper edge for each tray must be 2 mm. If it is
not 2 mm, adjust with SP1002-004 to -007, depending on which tray is not within the specified
2 mm.