Ricoh ADF DF7010, Руководство по обслуживанию на месте

Страница: 35 / 72

３
33
Chapter 3 2 ADF Section
(7) Removing the Timing Belt
1. Remove the ADF front cover.
→See Page 27
2. Loosen the tension’s fixing screw.
3. Pull the timing belt off the pulley, and remove
the timing belt.
Tension
Screw
Pulley
Pulley
Pulley
Timing belt
Reinstallation
IMPORTANT
● Be sure to adjust the tension after installing
the Timing belt.
→See Page 40
(8) Removing the ADF Clutch A/B
2. Remove the ADF rear cover.
→See Page 27
3. Disconnect the two connectors.
4. Remove the screw to remove the angle.
1. Remove the ADF document cover.
→See Page 24
5. Remove the ADF clutch A/B.
Reinstallation
IMPORTANT
● The ADF clutch A and ADF clutch B are not
the same type. Attach the correct one to
the correct position.
• ADF clutch A: 2-pin connector
• ADF clutch B: 3-pin connector
Angle
Angle
ADF Clutch A
ADF Clutch B
Screw
Connector
Connector