GTR057 Installation Manual:
Rev 2
9
GTR057 Detailed Programming Guide
User Settings
To enter programming mode
✱
Master code #
888888 is the default factory master code
To exit programming mode
✱
Note: All the steps below must be done after entering the keypad into programming mode
To change the master code
0 New Code # New code #
The master code is any 6 digits
Setting the working mode: Card, PIN or Card & PIN
Set valid
Card
or
PIN
users
3 1 2 #, Zone 1
3 2 2 #, Zone 2
Entry is by either
Card or PIN
(Factory default setting)
Set valid
Card
and
PIN
users
3 1 1 #, Zone 1
3 2 1 #, Zone 2
Entry is by
Card and PIN
together
Please Note:
When adding users, if the Card or PIN user has been enrolled already, you cannot add it again
on the same zone, or the device will give a bleep as error. Same PIN for both Zone 1 and Zone 2 is not valid,
if so, the PIN will be only valid for Zone 1.
Factory default setting: Card or PIN mode
To set user for Zone 1 ( 3 1 2 # )
