Manual
6330084330
Troubleshooting / operating errors
You are able to see errors and operating errors in the status messages of the LED display and then
correct them accordingly.
Replacing the battery
1. Remove the screw on the side of the cover using a TG 6
screwdriver.
2. Open the battery compartment and remove the battery
pack. Disconnect the two-pole plug-in connector from the
battery pack.
3. Connect the new battery pack using the plug-in connection
and insert the battery in the lock.
4. Close the battery compartment and screw down.
Codes are not deleted when a battery is replaced.
As a precaution the time should be set again after replacing the
battery.
Note: Please dispose of the empty battery pack properly in accordance with the valid
environmental regulations.
Battery monitoring / battery alarm
Automatic battery monitoring on the SAFE-O-TRONIC
®
lock ensures that it cannot be locked if
the battery voltage is too low.
There is an advance warning when all the LEDs flash twice. It is then advisable
to replace the
battery.
An alarm is triggered after a while if the battery is not replaced. This is indicated when the red and
green LEDs light up in turn three times. The battery must now be replaced. The lock can only be
opened in this condition but no longer locked.
Maintenance and care
SAFE-O-TRONIC
®
access
locks are maintenance free. Under no circumstances are the lock to
be oiled or greased with lubricants containing mineral oil.
Only use non-stick, residue-free cleaning agents and disinfectants for cleaning purposes. Do not use
any harsh cleaning agents, acids or lyes when caring for the product. Also do not use a pressure
cleaner.
It is also not permissible to hose down the lock, e.g. using a hose, and this can lead to destruction
and exclusion of liability.
10
www.richelieu.com
