Rice Lake Summit SD-1150-WP, Руководство по эксплуатации

Страница: 8 / 22

Summit SD-1150-WP Wheelchair Scale
4 Visit our website www.RiceLake.com
2.4 Assembly
The scale feet are shipped attached to the scale.
1. Ensure each foot is screwed in until the foot touches either the load cell or the underside of the deck.
2. Unscrew each foot three complete turns and level the scale so all of the feet are in contact with the floor.
3. Adjust corners not contacting the floor by unscrewing the feet until the feet contact the floor surface.
4. When all of the feet are contacting the floor, check the deck with the spirit level to ensure the scale is within 1/4 inch of level.
2.5 Electrical Interface to the Indicator
10' of 4-wire cable for connecting the scale to the weight indicator is supplied with each scale. The junction box is accessible
through an access plate located on the side of the scale. Use the following steps to wire the junction box:
1. Remove the two #10 x 3/8 inch screws.
2. Slide the junction box assembly out of the deck.
3. Open and remove the top of junction box.
4. Push the cable end into the junction box through a cord grip.
5. Connect the wires to the indicator terminal (
Figure 2-2 ) as shown in Table 2-1.
6. Pull out excess and tighten the cord grip to hold the cable snugly.
Figure 2-2. Junction Box Wiring
7. The cable must be routed to the indicator in a manner that will protect the cable from damage. The method of cable
protection in non-washdown applications is shown in Figure 2-3 . Leave a loose coil of excess cable under the scale to
facilitate lifting of the scale for servicing and cleaning.
Figure 2-3. Cable Protection
Cable Color Code Junction Box
White +EX
Green -EX
Black +SIG
Red -SIG
Table 2-1. Titanium 10-Button Indicator Junction Box Connections
Indicator Terminal Location
Load Cell Cable Scale Floor