Rice Lake RoughDeck FXB, Руководство по установке

Страница: 10 / 18

RoughDeck FXB
6 Visit our website www.RiceLake.com
2.4 Assembly
1. Cut bands holding the load cell package from lever arm and remove the load cell with wire rope.
The load cell is a delicate device and can be damaged if dropped, twisted when mounting, or shock loaded.
2. Insert a block under the primary lever so it fits snugly. Remove the shipping bolt and spacer. The shipping bolt is
placed between the load cell support frame and the nose iron (in place of load cell) during shipping (see Figure 2-4
and Figure 2-5 ).
3. The load cell is shipped with wire rope. Remove the outer nut from the load cell wire rope..
Figure 2-4. Load Cell Setup
4. Screw the inner nut on the wire rope flush with the top of the threads.
5. Remove the load cell mounting bolt from the top of the cell.
6. Screw the short threaded end of the wire rope through the bottom of the load cell until it’s flush with the top.
The weigh platform frame and scale base are marked on the corner near the load cell for proper assembly.
7. Carefully lower the load cell into position at an angle so the wire rope threaded rod end goes through the hole of the
nose iron first. If used, position the spacer between the load cell support frame and the load cell.
The 3/4" spacer is used beginning with the 30" x 30" 2000 lb model and those higher, with the exception of the 48" x
48" 20000 lb models which use a 1" spacer.
8. Position the load cell so the signal cable will travel directly out of the exit hole in the base as shown in Figure 2-5.
Figure 2-5. FXB Interior
CAUTION
Load cell support frame
3/4" or 1" spacer (see note
below on spacer sizes)
Inner (top) nut
Nose iron
Outer (bottom) nut)
Wire rope
Load cell
Note
Note
Load cell
spacer
Exit hole for the
signal cable