Rice Lake RL-MPS, Руководство по эксплуатации

Страница: 10 / 18

6 Mechanical Physician Scale Installation and Operation Instructions
2.3 Height Rod Installation (for those models equipped with height rods)
Some models of the Mechanical Physician Scale comes with height rods. Use the following steps to install the
height rod.
1. Insert the back side slotted holes of the height rod into the two bolts on the front side of the pillar as
shown in Figure 2-8. One is located at the top of the pillar and the other towards the bottom of the pillar.
Figure 2-8. Attach the Slotted Screw Location onto the Pillar Bolt Location
2. Use the enclosed wrench to tighten the two hex-head screws, but ensure not to over tighten.
3. To raise or lower the height rod, press the red button at the top of the height rod and raise up or down.
Slotted holes