Rice Lake RL-DBS-2, Техническое руководство

Страница: 9 / 18

Setup
© Rice Lake Weighing Systems ● All Rights Reserved 5
3.2 Initial Setup
Use the following steps to set up and verify the RL-DBS-2 upon initial power up and periodically thereafter.
1. Plug the AC adapter cable into the back of the scale ( Figure 2-1 on page 3 ) and the AC adapter plug into a power
source.
2. Turn on the scale. A self test runs and 0.00.0 lb or 0.00 kg displays when complete.
3. Place a weight, not exceeding 40 lb, on the scale. The weight measurement is complete when
o
displays.
4. Press
LB/KG
to select unit of measure, lb/oz or kg.
5. Remove the weight from the scale. To display the weight again, press
RECALL
Note
.
If setup procedure fails, see Section 6.3 on page 9 . If the problem is not resolved, refer to a qualified service provider.
3.3 Set Units
The RL-DBS-2 can be set up to display weights in lb only, kg only or to toggle between lb and kg units on the scale.
3.3.1 KG Units Only
Lock the weight units to display in kg only.
1. Ensure the scale is turned on.
2. Press
LB/KG
to change the displayed units to kg.
3. Press and hold
LB/KG
for five seconds until kg flashes.
4. Release
LB/KG
. The weight units are now locked in kg. Pressing
LB/KG
does not switch units to lb.
3.3.2 LB Units Only
Lock the weight units to display in lb only.
1. Ensure the scale is turned on.
2. Press
LB/KG
to change the displayed units to lb.
3. Press and hold
LB/KG
for five seconds until lb oz flashes.
4. Release
LB/KG
. The weight units are locked in lb. Pressing
LB/KG
does not switch units to kg.
3.3.3 Unlock Units
Unlock the weight units to toggle between lb and kg.
1. Ensure the scale is turned on.
2. Press and hold
LB/KG
for five seconds until kg or lb oz flashes.
3. Release
LB/KG
. Pressing
LB/KG
toggles units between lb and kg.