Rice Lake Revolution 680 Synergy Plus, Техническое руководство

Страница: 67 / 80

Maintenance
© Rice Lake Weighing Systems ● All Rights Reserved 61
10.4 Battery Replacement
The battery life varies depending on use. It is recommended to replace the battery every three years, or sooner, if left powered
off for extended periods of time to prevent data loss in the event of a power failure.
Use the Revolution configuration utility (
Section 6.0 on page 43 ) or EDP commands ( Section 7.0 on page 44 ) to store a copy of
the 680 configuration on a PC before attempting battery replacement. The 680 configuration can be restored from the PC if data
is lost.
Risk of explosion if battery is replaced with an incorrect type. Dispose of used batteries according to federal,
state and local regulations.
Figure 10-1. Non-Conductive Screw Driver Placement
To replace the battery, use the following procedure:
1. Disconnect power to the indicator.
2. Remove backplate as described in
Section 2.3 on page 5 .
3. Place the tip of a non-conductive flat head screw driver between negative contact and battery.
4. Twist screw driver to release battery from holder.
5. Press new replacement battery straight into the battery holder with the positive side up. See
Section 2.9 on page 12
for replacement battery details.
10.5 Board Replacement
To replace a 680 board, use the following procedure:
1. Disconnect power to the indicator.
2. Remove backplate as described in
Section 2.3 on page 5 .
3. Label connections for re-installation to board.
4. Disconnect all connections from the board.
5. Remove the four corner screws securing the board, then lift the board from the enclosure.
6. Place new replacement board in place and secure with previously removed screws. See
Section 2.9 on page 12 for
replacement board details.
7. Reconnect all connections to the board.
Always verify indicator has been returned back to a safe state with the proper installation of all connections and
a complete functions test before reinstalling the backplate and returning the indicator back to service.
WARNING
ASSY
PN/Rev
RICE LAKE
INSERT
SIDE UP
+
CR2032 CR2032
LED3
LE
D
1
LE
D
2
IMPORTANT