Rice Lake Revolution 680 Synergy Plus, Техническое руководство

Страница: 58 / 80

680 Synergy Plus – Digital Weight Indicator
52 Visit our website www.RiceLake.com
7.14 Weigh Mode Commands
These commands function in the weigh mode. Non weight related commands work in setup mode.
7.15 Batching Control Commands
The commands listed in Table 7-15 provide batching control through a communications port.
Command Description Values
CONSNUM Returns current consecutive number value 0–9999999, 0 (default)
UID Set unit ID Up to 6 alphanumeric characters, 1 (default)
SD Set or return the current system date MMDDYY , DDMMYY, YYMMDD, or YYDDMM. Enter six-digit date using the
year-month-day order specified for the DATEFMT parameter, using only the last two
digits of the year; The current system date is returned by only sending SD
ST Set or return the current system time HHMM (enter using 24-hour format)
The current system time is returned by only sending ST
SX# n Start serial data stream(s) OK or ??
An EX command sent while in setup mode does not take effect until the indicator is
returned to weigh mode
EX# n Stop serial data stream(s)
RS Reset system Soft reset; Used to reset the indicator without resetting the configuration to the
factory defaults
SF# n Returns a single stream frame from scale n (n=1)
using the standard Rice Lake format.
--
XA# n Returns the accumulator value in displayed units nnnnnnnnn UU
XAP# n Returns the accumulator value in primary units
XAS# n Returns the accumulator value in secondary units
XG# n Returns the gross weight in displayed units nnnnnnnnn UU
XGP# n Returns the gross weight in primary units
XGS# n Returns the gross weight in secondary units
XN# n Returns the net weight in displayed units nnnnnnnnn UU
XNP# n Returns the net weight in primary units
XNS# n Returns the net weight in secondary units
XT# n Returns the tare weight in displayed units nnnnnnnnn UU
XTP# n Returns the tare weight in primary units
XTS# n Returns the tare weight in secondary units
For commands ending with #n , n is the scale number (1)
Table 7-14. Weigh Mode Commands
Command Description Values
BATSTART Batch Start If the BATRUN digital input is active or not assigned, the BATSTART command can be used to
start the batch program
BATSTOP Batch Stop Stops an active batch and turns off all associated digital outputs; Requires a Batch Start to
resume processing
BATPAUSE Batch Pause Pauses an active batch and turns off all digital outputs except those associated with Concurrent
and Timer setpoints; processing is suspended until the indicator receives a Batch Start signal;
pressing the BATSTRT digital input, BATSTART serial command, Batch Start softkey or the
StartBatch function (in iRite) resumes the batch and re-energizes all digital outputs turned off by
the Batch Pause
BATRESET Batch Reset Stops the program and resets the batch program to the first batch step; use the BATRESET
command after making changes to the batch configuration
BATSTATUS Batch Status Returns XYYY where X is S (if the batch is stopped), P (if the batch is paused),
R (if the batch is running); and YYY is the setpoint number the batch is currently on (1-8)
Table 7-15. Batching Control Commands