Setup
© Rice Lake Weighing Systems
●
All Rights Reserved
11
4.1.1 Set Function Key
The MSI-4260 IS has one user definable key (
) on the front panel, that can be programmed to one of several functions.
To set the function key use the following steps:
1. Press and hold
and
.
displays
.
2. Press
. The current user key function displays.
3. Press the
to scroll through the available functions.
4. Press
when the desired function is displayed.
displays.
5. Press
.
displays, the unit exits setup and stores the settings.
Press
at any time to cancel the procedure.
4.1.2 Test
To run a test, press the F-key which is programmed to
TEST
. The display automatically scrolls through the following:
Lights all LEDs at once.
Displays
followed by the software version number.
Displays
followed by the battery voltage.
Displays
followed by the display counting from 00000 to 99999.
Displays
followed by the C-CAL value.
Other internal tests are performed and if any test fails, an error code displays. See
for information on
the troubleshooting guide.
To stop the automatic test procedure, press the
F-key again within two seconds to enable a single step mode. Use the F-key to
scroll through the available test functions and
to start or display the individual tests.
Press
to exit individual tests, press it again to exit from the test function.
4.1.3 Total
Set the total parameter desired for the F-key.
1. If the unit is turned off, press and hold
then press
If the unit is on, press
and
simultaneously.
displays.
2. Using the
, scroll to
.
3. Press
. The currently saved total mode displays.
4. Press
to scroll through the choices.
5. With choice displayed, press
to select.
displays.
6. Press
to save and exit to weighing mode or press
to continue to another
Setup
menu item.
The total mode must be programmed from the Setup menus before the
USER
key will function.
USER
F
USER
F
es
POWER
TARE
T
USER
F
TARE
T
st
ZERO
Note
es
POWER
TARE
T
Note
st
ZERO
USER
F
es
POWER
USER
F
es
POWER
USER
F
TARE
T
USER
F
TARE
T
st
ZERO
USER
F
Note
