Rice Lake LaserLight Series, Руководство по установке, Страница: 22 / 46

LaserLight Series
18 Visit our website www.RiceLake.com
3.4 Testing the Remote Display
The LaserLight remote display provides a test to check the hardware of the remote display. These tests can be accessed
through the main menu ( Figure 3-7 ).
Figure 3-7. Test Menu Choices
3.4.1 Display
When this feature is enabled, all LEDs remain lit until the ENTER button is pressed ( Figure 3-2 on page 12 ).
Serial Menu
Port 1 Parameter Choices Description
Level 3 submenus
BAUD 1200 Baud rate; Selects the transmission speed for Port 1
2400
4800
9600
19200
PARITY ODD Selects the parity of data transmitted from Port 1
EVEN
NONE
DATA BITS 7 Selects the number of data bits transmitted from Port 1
8
STOP BITS 1 Selects the number of stop bits transmitted from Port 1
2
ECHO ON Enable this feature to allow echoing between the remote display and other devices; If enabled and
echoing, the baud settings must be set equal to or greater than the device being echoed to
OFF
LOCK OFF If this parameter is disabled, the echo port display uses the same communications settings as the
indicator port after an Auto-Learn is run
ON
Table 3-6. Port 1 Serial Menu Parameters
CONFIG SERIAL TEST VER
DISPLY LOOP BK DIGOUT DIGIN
LL-OFF
LH-grn arrow HL-grn circle HH-red circle
XX