Riccar Radiance RAD.5, Руководство по обслуживанию

Страница: 8 / 38

5
071807 II. Maintenance Procedures
II. Maintenance Procedures
A. Disassembly Instructions
A. Step 1.
Figure C. Location of Nozzle Cover Screws
1. Remove the handle and dust cover.
1
2
3
4
5
2. Place the vacuum face down on the bench.
3. Remove the base plate by removing the 2 (two) screws.
4. Remove the agitator/brushroll.
5. Remove the 5 (five) mounting screws on the underside of the
nozzle base tray. (See Figure C. Location of Nozzle Cover
Screws )
A. Step 2. Removing the Back Path and Cover
1. Remove 1 (one) screw in the tools activation dial/rotational
valve handle and 8 (eight) screws on the back path and hose.
2. Remove tools activation dial/rotational valve handle and back path cover.
3. Remove 1 (one) screw from the micro switch and then the remaining 13 (thirteen) screws in the back cover.
4. Remove the back cover allowing the micro switch to slide through the slot in cover.
5. Remove the tool clips.
A. Step 3.
NOTE: Skip to A. Step 4. if wiring harness is NOT being changed.
1. If wire inlet seal (foam seal where the wire goes through the dust compartment) is installed, remove it at this time.
2. Remove the wire harness connector from the dust compartment and the micro switch from the wiring harness.
A.
Step 4.
Turn the vacuum over, depress handle release, and lay flat. Remove the nozzle cover.
A. Step 5.
WARNING - If the vacuum is not in the upright position before continuing with the next step, injury may occur or vacuum
may be damaged.
1. Set the vacuum in the upright position and remove the 2 (two) screws from the spring assist bar.
2. Lay the vacuum flat. Remove the 3 (three) screws from the direct air motor inlet duct cover, and 1 (one) screw from each of
the wire strain relief (2 each) .
3. Remove the belt.
4. Remove 3 (three) screws from the idler cover and spring.
5. Disconnect the light lead connector from the light board (disconnect the ground wire if necessary).
6. Remove the 2 (two) screws from each of the pivot brackets.
A. Step 6.
1. Lift the dust compartment up out of the nozzle base tray assembly.
2. Remove the pivot bushings and the direct air motor inlet seal from the dust compartment.
A. Step 7.
1. Remove the 4 (four) screws holding the motor cover on the dust compartment.
2. Lift up on the motor cover and set it aside. -continue on next page