WARNING:
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE. DO NOT REMOVE COVER. PILOT LAMPS SOLDERED IN
PLACE. NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
RISK
O
F
ELE
C
TRI
C
SHO
C
K
DO
NOT
O
P
EN
CAUTION
The lighting flash with arrow
-
head symbol, within an
equilateral triangle, is intended
to alert user to the presence of
uninsulated “dangerous
voltage” within the product’s
enclosure that may be of
sufficient magnitude to
constitute risk of electric shock
to persons.
CAUTION: TO REDUCE THE RISK
OF ELECTRIC SHOCK, DO NOT RE
-
MOVE COVER (OR BACK). NO
USER - SERVICEABLE PARTS
INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
The exclamation point within an
equilateral triangle is intended
to alert user to the presence of
important operating and
maintenance (servicing)
instruction in the literature
accompanying the appliance.
Specification
Frequency Range : AM 520 - 1600 KHz
: FM 87.5 - 108.5 MHz
USB Port 2.0 : Full Speed 512MB - 4GB
(Support FAT16, FAT32)
Power Consumption : 85W
Antennas : External FM antenna wire
: Built-in ferrite AM bar
Power Source : AC 230V ~ 50Hz
Speaker Size : 6 1/2” Dynamic type x 2
Speaker Ohm : 4 Ohm
Speaker Watt : 40W
Speaker Size : 2 1/2” Tweeter type x2
Speaker Ohm : 8 Ohm
Speaker Watt : 10W
Power Output : 13W x 2
*Note : AM = MW
*DESIGN AND SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.
IMPORTANT SAFEGUARDS FOR AUDIO PRODUCTS
PLEASE READ CAREFULLY THE FOLLOWING IMPORTANT SAFEGUARDS THAT ARE
APPLICABLE TO YOUR EQUIPMENT.
1. Read Instructions
- All the safety and operating instructions should be read before the
appliance is operated.
2. Retain Instructions
- The safety and operating instructions should be retained for future
reference.
3. Heed Warnings
- All warnings on the appliance and in the operating instructions should be
adhered to.
4. Follow Instructions
- All operating and use instructions should be followed.
5. Water and Moisture
- The appliance should not be used near
water-for example, near a bathtub, washbowl, kitchen sink, laundry tub,
in a wet basement, or near a swimming pool and the like.
6. Carts and Stands
- The appliance should be used only with a cart or stand
that is recommended by the manufacturer.
6A.
An appliance and cart combination should be moved with care. Quick stops, excessive force,
and uneven surfaces may cause the appliance and cart combination to overturn.
7. Wall or Ceiling Mounting
- The appliance should be mounted to a wall or ceiling only as
recommended by the manufacturer.
8. Ventilation
- The appliance should be situated so that its location or position does not interfere
with-its proper ventilation. For example, the appliance should not be situated on a bed, sofa,
rug, or similar surface that may block the ventilation openings; or, placed in a built-in installation,
such as a bookcase or cabinet that may impede the flow of air through the ventilation openings.
9. Heat
- The appliance should be situated away from heat sources such as radiators, heat
registers, stoves, or other appliances (including amplifiers) that produce heat.
10.Power Sources
- The appliance should be connected to a power supply only of the type
described in the operating instructions or as marked on the appliance.
11.Grounding or Polarization
- Precautions should be taken so that the grounding or polarization
means of an appliance is not impeded.
12.Power - Cord Protection
- Power-supply cords should be routed so that they are not likely
to be walked on or pinched by items placed upon or against them, paying particular attention
to cords at plugs, and the point where they exit from the appliance.
13.Cleaning
- The appliance should be cleaned only as recommended by the manufacturer.
14.
This product is designed for use with the antenna attached and should not be connected to
any other external antennas.
15.Non-use Periods
- The power cord of the appliance should be unplugged from the outlet
when left unused for a long period of time.
16.Object and Liquid Entry
- Care should be taken so objects do not fall and liquids are not
spilled into the enclosure through openings
17.Damage Requiring Service
- The appliance should be serviced by qualified service personnel
when:
A. The power-supply cord of the plug has been damaged; or
B. Objects have fallen, or liquid has been spilled into the appliance; or
C. The appliance has been exposed to rain; or
D. The appliance does not appear to operate normally or exhibits a marked change
inperformance; or
E. The appliance has been dropped, or the enclosure damaged.
18.Servicing
- The user should not attempt to service the appliance beyond that described in
the operating instructions. All other servicing should be referred to qualified service personnel.
