6
G
B
SPARK Wi-Fi is a flasher managed via radio by the MASTER Wi-Fi card.
CONNECTING THE BATTERIES AND PROGRAMMING
-
Remove diffuser (4).
-
Remove plastic guard (5).
-
Unhook electronic card assembly and battery carrier from plastic base (1).
-
Loosen gland bolt of electronic card.
-
Remove electronic card to access battery compartment.
-
Insert 3 alkaline batteries type C with 1.5V and check the polarities (3 ACG9518).
-
Reposition electronic circuit on spacers and fasten screws again.
-
Affix plastic base of SPARK Wi-Fi (2) in proximity to automation so it is visible from a
maximum distance of 20 m with respect to the electronic control panel where the MASTER
Wi-Fi card resides.
-
Reconnect electronic card assembly and battery carrier to plastic base.
PROGRAMMING
-
Press and keep pressed the PROG. RX key on the MASTER Wi-Fi card for at least three
seconds.
-
When releasing the PROG. RX key, the bicolor DL7 LED will flash red for 10 seconds.
-
Press the S4 PROG. TX key on the SPARK Wi-Fi card to send the radio signal to the
MASTER Wi-Fi.
-
Correct memorization is indicated by:
-
Buzzer sound;
-
On MASTER Wi-Fi card the bicolor red DL7 LED becomes green;
-
On SPARK Wi-Fi card the red DL7 LED flashes three times.
-
To complete programming, wait for 10 seconds or press the PROG. RX key for an instant
on the MASTER Wi-Fi card.
-
Replace protection device (5).
-
Mount diffuser (4) and fasten it with the two screws supplied (6).
FUNCTIONAL CHECK
Execute command for the door and check proper functioning of SPARK Wi-Fi.
NOTE:
SPARK Wi-Fi flashes according to the time set on the RIB control panel.
The flashing time is limited to a maximum of 60 seconds.
More than one SPARK Wi-Fi blinker can be memorized by the MASTER Wi-Fi and
will all blink simoultanesly.
S4
PROG.
TX
DL7
red
3
LED
12/24V ac/dc
PROG. RX
DL7 BICOLOR
DRL5X15Z
DAC48X16
DAC35X95
CVA1962
CPL1383
CPL1381
CPL1380
BC07064
