Rhopoint NOVO-SHADE DUO, Руководство пользователя

Страница: 18 / 35

16
Taking a single reflectance (shade) measurement
Turn the instrument on by pressing the POWER key. For two
seconds the display will show the following message:
Rhopoint
Novo-Shade Duo
Rhopoint
Shade Mode
ANGLE Value No.
45/0 99.7 1
The display will then indicate the current measurement mode of the
instrument.
*Note: To take reflectance readings the instrument should be set to
Shade mode. For the procedure to switch between modes see pages 14-15.
Press the READ key to initiate a reading. A line of arrows will
move across the screen whilst the instrument takes a measurement.
After a further two seconds the instrument will revert to
measurement mode as seen below:
ANGLE Value No.
45/0 0 0
Once the instrument has taken the reading the display will show the
results as in the example below:
ANGLE Value No.
45/0>>>>>
1. The value shown in the display is the reflectance value for the
section of the sample covered by the aperture.
2. This value has been stored in the memory and the number of
stored readings increased by one.
1. 2.