RHINO SE42, Руководство оператора

Страница: 82 / 138

ASSEMBLY
SE42 03/08 Assembly Section 3-4
© 2008 Alamo Group Inc.
ASSEMBL
Y
HYDRAULIC RELIEF ASSEMBLY (P/N 3570)
Hydraulic Relief Assembly (3570), also known as check chain, is available for attachment to front of cutter as
an accessory. Check chains are used to control cut height and especially allows cutter to always be lowered to
the same preset cut height.
Drill a 11/16” hole through each lifting lug 2-1/2” below the lift pins and 5/8” from the front of the lug. See
Figure
6.
Install lower end of check chain (3) to hitch ears, through lower holes using capscrews and lockwashers.
Tighten securely.
Install chain lugs (2) on either side of tractor top link mounting (4) using bolt or pin of required diameter and
length. Cat. I kit requires a 3/4” diameter bolt. Install top end of check chains in brackets (2).
Cutting height is then set by placing proper chain link in keyhole slot. Cutting height is easily adjustable by
hooking chain higher or lower in the keyhole brackets (2).
For additional safety in transport, raise mower as high as possible without having driveline hit decks and
shorten check chains all possible to prevent inadvertent falling in transport.