Under-Counter Beverage Cooler
Edition: A (March 2012) - 6 -
1.3 Positioning the chiller
·
Please position the cabinet carefully being careful not to bump it.
·
The power supply flex exits the chiller at the bottom right hand side (as
viewed from the front). For ease of access, the flex should be retrieved prior to
positioning the chiller in its final location.
·
The maximum recommended ambient temperature for this chiller is 42
℃
.
·
Avoid positioning the appliance in direct sunlight or damp areas.
·
Allow adequate space for the door(s) to fully open.
·
Ensure that this chiller is positioned on a level surface, so as to allow the
door(s) to shut and seal correctly, as well as to allow proper drainage from the
evaporator tray, to prevent any overflow. If necessary, adjust the screw feet of
the appliance to make it level.
·
Do
NOT
overload the power supply. Always ensure that the power supply is
adequate for the electrical requirements specified on the rating label. The
rating label is located inside the chiller, on the right hand side wall. If in doubt,
please consult a qualified electrician. Caution: Never use extension leads or
multiple adaptors.
Note: If the unit has not been stored or moved in an upright position, let it stand
upright for approximately 12 hours before operation. If in doubt allow to stand.
Ventilation
·
All models: All models must have clear and unobstructed ventilation from the
entire surface area of the front grille.
·
The 2 and 3 door models may be built into an enclosure without the need for
ventilation other than at the front.
·
The single door coolers
MUST
have a minimum ventilation space of 20mm at
sides and rear.
·
WARNING:
Failure to provide the minimum ventilation space will
harm the performance of your chiller, could cause fire and will invalidate the
warranty.
·
WARNING:
Keep clear of obstruction all ventilation openings in the
appliance enclosure or in the structure for building in.
