RHINO FM84A, Руководство оператора, Страница: 80 / 128

OPERATION
Operation Section 4-6
OPERA
TION
FM84A 09/03
© 2004 Alamo Group Inc.
2.2 Tractor Safety Devices
If transporting or operating the tractor and mower near a public roadway, the tractor must be equipped with proper
warning lighting and a Slow Moving Vehicle (SMV) emblem which are clearly visible from the rear of the unit. Lights
and a SMV emblem must be equipped directly on implements if the visibility of the tractor warning signals are
obscured.
Maintain all manufacturer equipped safety shields and guards. Always replace shields and guards that were
removed for access to connect, service, or repair the tractor or mower. Never operate the tractor PTO with the
PTO master shield missing or in the raised position.
2. TRACTOR REQUIREMENTS
The tractor used to operate the mower must have the power capacity to lift, pull, and operate the Power Take Off
(PTO) at the mower’s rated speed while traveling at a ground speed between 2 and 5 MPH. Operating the mower
with a tractor that does not meet the following requirements may cause tractor or mower damage and be a
potential danger to the operator and passersby.
Tractor Requirements and Capabilities
¾
ASAE approved Roll-Over Protective Structure (ROPS) or ROPS cab and seat belt.
¾
Tractor Safety Devices............………........................... Slow Moving Vehicle (SMV) emblem, lighting,
PTO master shield
¾
Tractor Horsepower -Minimum .....................................FM84A 30 hp,
-Maximum…….............................. FM84A 50 hp,
¾
3-Point Hitch- ..…………...............................…........... CAT I, Floating Hitch
¾
Front End Weights..…………...............................…..... As needed to maintain 20% weight on front axle
¾
Power Take Off.........………......................................... 540 RPM 6-spline 1-3/8” diameter output shaft
2.1 ROPS and Seat Belt
A Roll-Over-Protective-Structure (ROPS) and seat belt are essential to protect the operator from falling off the
tractor, especially during a roll over where the driver could be crushed and killed. The ROPS and seat belt must be
used in conjunction with one another. Only operate the tractor with the ROPS in the raised position and seat belt
fastened. Tractor models not equipped with a ROPS and seat belt should have these life saving features installed
by an authorized tractor dealer.
Operate this Equipment only with a Tractor equipped with an approved roll-over-
protective system (ROPS). Always wear seat belts. Serious injury or even death
could result from falling off the Tractor--particularly during a turnover when the
operator could be pinned under the ROPS.
(SG-7)
WARNING!