5
Fit Jerry Can Holder to Plank:
Lower the jerry can holder onto the plank where you would like to fit the unit. Place two M8 channel nuts into the slot at
the end of the plank and slide the channel nuts under the tabs at each end of the jerry can holder. Fit the hardware to
the channel nuts as shown and fasten in position.
Fitment Note:
Jerry can holder must always be fitted to the outside plank of the tray. It must also be centred
over one of crossbars running beneath the planks as the strap brackets need to be fitted to the crossbar.
Multiple Jerry Can Holders:
When fitting multiple jerry can holders to the same tray the load must be
distributed evenly over the tray. Fitment note above must also be followed.
Rhino Pioneer Alloy Tray Fitment
Plank
M8
Channel Nut
M8 x 16mm Hex Screw
M8 x 17mm Flat Washer
M8 Spring Washer
Slot
6
Insert Jerry Can:
Insert the jerry can to be used into the jerry can holder as shown below.
It is important to keep
the filler cap facing
upwards when you
load the jerry can into
the holder.
Horizontal
Jerry Can Holder
Vertical
Jerry Can Holder
Page 4 of 5
43107
Rhino Jerry Can Holder
43108
Rhino Jerry Can Holder - Horizontal
