Rheem Stellar, Руководство пользователя и инструкции по установке

Страница: 7 / 40

ABOUT YOUR WATER HEATER
7
SINGLE ELEMENT MODEL
This type of water heater has one heating unit with
its own thermostat. The heating unit is at the base
of the water heater and can be connected to a
Continuous or Off-Peak electricity supply. The
thermostat is factory set to 65°C and is
tradesperson adjustable between 60°C to 75°C.
Continuous electricity supply
This type of connection is suited to where the
storage capacity is less than the normal daily
usage.
Off-Peak electricity supply
This type of connection will only allow heating
to occur during set hours. A volume of water
sufficient for the day’s total use is heated and
stored. This type of heating will be more
economical due to reduced tariffs by the
electricity authority.
TO TURN OFF THE WATER HEATER
If you plan to be away from home for only a few nights, we suggest you leave
the water heater switched on.
If it is necessary to turn off the water heater:
Switch off the electrical supply at the isolating switch to the water heater.
Close the cold water isolation valve at the inlet to the water heater.
TO TURN ON THE WATER HEATER
Open the cold water isolation valve fully on the cold water line to the water
heater.
Switch on the electrical supply at the isolating switch to the water heater.
GOING ON HOLIDAY?
If you plan to be away from home for one or two nights, we suggest you leave
the water heater switched on. However, if you plan to stay away more than a
few nights, conserve energy by switching the water heater off at either the
switchboard or isolating switch (if one is installed).
Note: When the electrical supply is switched back on, the water heater will take
some time to reheat the water. Depending upon the power supply connection,
hot water may not be available until the next day.