HEAT PUMP AND TANK ASSEMBLY
22
15.
Wall Bracket:
Drill a hole in the wall to receive a suitable anchor for the
heat pump module wall bracket.
Retrieve the heat pump wall bracket from the kit bag and fix to the
wall using the 8 mm wall plug and 25 mm x 8 G screw, suitable for a
masonry wall, provided. If this anchor is not suitable for the wall
construction, then an alternative method of fixing to the wall will need
to be used.
Ensure the horizontal section of the wall bracket is below the vertical
section.
16.
Wall Bracket Tab:
Fold out the wall bracket tab at the top of the upper
rear panel of the heat pump module, using a pair of pliers.
Step 16
fold out wall bracket tab
17.
Position Heat Pump Module:
Position the heat pump module hard
against the wall and slightly to the right of its final location.
Slide the heat pump module to the left, so the slots in the feet of the
heat pump module fit around the four (4) dynabolts.
Note:
Ensure the feet of the heat pump module are flat and have not
been bent up during handling, otherwise the dynabolt nuts may not be
able to be fully tightened.
Tighten the nuts on the dynabolts, securing the feet of the heat pump
module to the slab or solid base.
