IXTAPA & TOLUCA PROPANE TANK COVER OWNER’S MANUAL
9
SET-UP
CONTINUED
CONNECTING (& DISCONNECTING) LP GAS CYLINDER
Once the propane cylinder is secured and the
regulator and hose are connected with confirmation
of no gas leaks, place the box portion of the propane
tank cover onto the metal base
(Figure G: #1).
Place
the lid portion of the propane tank cover onto the
box
(Figure G: #2).
Do not sit or stand on top of propane tank cover.
FINAL ASSEMBLY
CONNECTING THE LP GAS CYLINDER
Check to make sure there is no debris in the head of
the LP gas cylinder or in the head of the regulator
valve. Make sure you check the burner and burner
ports as well. Connect the gas line to tank by turning
knob clockwise as shown in
Figure E.
Always hand-tighten only.
DISCONNECTION THE LP GAS CYLINDER
Make sure the valve on the LP gas tank is
OFF
.
Disconnect the gas line by turning the knob counter
clockwise (as shown in
Figure F
)
until it disengages
from the valve.
To Fire Table
1
2
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSES
REMEDY
Fire table will not light
Air in gas line
If new install, may take several
attempts to purge air
Debris in gas line
Confirm gas line is clear
(no insulation, dirt, plastic,
excessive pipe sealer, etc.)
Improper gas pressure
Confirm proper gas pressure
Fire table will not stay lit
Improper gas pressure
Confirm proper gas pressure
Improperly applied media
Review media application
Noise
Note:
The movement and
combustion of gas will
create low, unavoidable
levels of noise.
Passage of air/gas across
irregular surfaces
Remove any tight bends or
kinks in gas supply line
Excessive gas pressure on
natural gas units
Check or reset gas regulator
pressure
Fire table is smoking/
sooting excessively
Note:
It is natural and
unavoidable for appliance
sets to produce moderate
levels of carbon (soot)
where flames contact
the media
Poor fuel quality
Exchange LP Gas Cylinder
with a new tank
Excessive flame impingement
or blockage
Separate the media to allow
more flame passage
Improper fuel and/or air
mixture
Remove any foreign items from
the flame pattern and check for
proper orifice sizing
Burner flame is too low
or too high
Incorrect gas supply or
pressure
Check for proper gas supply
pressure
Blocked burner orifice or
burner ports
Free burner orifice and burner
ports of any debris or blockage
Improper burner orifice size
Verify proper burner orifice
sizing
Unwanted odors
Gas leak, see
Warning
Statement
Check for and seal all gas leaks
Figure E
Figure F
Figure G
