Zephyr 52" Ceiling Fan
Step 2. Motor to Receiver Electrical Connections: Connect the WHITE wire from the
fan to the WHITE wire marked "TO MOTOR N" from the Receiver. Connect the
BLACK wire from the fan to the BLACK wire marked "TO MOTOR L" from the
Receiver. Connect the BLUE wire from the fan to the BLUE wire marked "For Light"
from the Receiver.
NOTE: If your ceiling fan features an UP Light: Connect the ORANGE wire from the
fan to the ORANGE wire marked "For Up Light" from the Receiver. Otherwise
disregard this step and proceed to secure all wire connections with the plastic wire
nuts provided. (Fig. 13)
Note: Fan must be installed from a maximum distance of 40 feet from the
transmitting unit for proper signal transmission between the transmitting unit and the
fan's receiving unit.
Step 3. Receiver to House Supply Wires Electrical Connections: Connect the WHITE
wire (Neutral) from the outlet box to the WHITE wire marked "AC in N" from the
receiver. Connect the BLACK wire (Hot) from the outlet box to the BLACK wire
marked "AC in L" from the receiver. Secure all wire connections with the plastic wire
nuts provided. (Fig. 13)
Step 4. If your outlet box has a GROUND wire (Green or Bare Copper) connect this
wire to the Hanger Ball and Hanger Bracket Ground wires. If your outlet box does
not have a Ground Wire, then connect the Hanger Ball and Hanger Bracket Ground
Wires together. Secure wire connection with the plastic wire nut provided. (Fig. 13)
After all splices are made, check to make sure there are no loose strands. As an
additional precaution we suggest to secure the plastic wire connectors to the wires
with electrical tape.
FINISHING THE INSTALLATION
Step 1. Remove 1 of the 2 screws from the bottom of the hanger bracket and loosen
the other one half a turn from the screw head.
Step 2. Slide the canopy up towards the hanger bracket and place the key hole on
the canopy over the screw on the hanger bracket, turn canopy until it locks in place
at the narrow section of the key holes. (Fig. 14)
Step 3. Align the circular hole on canopy with the remaining hole on the hanger
bracket, secure by tightening the two set screws.
Note: Adjust the canopy screws as necessary until the canopy and canopy cover are
snug.
ATTACHING THE FAN BLADES
Insert one fan blade into the blade slot on the motor housing and secure with the
blade support plates and screws. Securely tighten screws. Repeat process with
other blades. (Fig. 15)
INSTALLING THE MOUNTING PLATE
Step 1. Remove 1 of 3 screws from the mounting ring and loosen the other 2
screws. (Do not remove)
Step 2. Place the key holes from the mounting plate over the 2 screws previously
loosened from the mounting ring, turn mounting plate until it locks in place at the
narrow section of the key holes. Secure by tightening the 2 screws previously
loosened and the one previously removed. (Fig. 16)
Step 2. Raise glass shade up against bottom of fan housing and secure it to the fan
by turning the glass shade clockwise until snug. DO NOT OVERTIGHTEN. (Fig. 9)
