RGBlue LM4.2K2200G, Инструкция по эксплуатации, Страница: 48 / 53

Maintenance after Use and Recovery Function
• After fi nishing the use of the product, remove the lens, etc.
(without disconnecting the modules) and soak the product in
fresh water under normal temperature for more than one hour to
eliminate the salt content.
• After taking the product out of the fresh water, wipe with a dry
cloth to eliminate moisture and let the product dry naturally in a
place not exposed to direct sunlight.
CAUTION : Do not dry the product with a hair dryer
or direct sunlight, as this may cause
degradation or deformation of the product
and O-ring, which may eventually lead to a
failure or water penetration.
• When the product is not to be used for a long period, disconnect
the Light Module and Battery Module, and attach the module
cap to the Battery Module before storing the two modules.
• The special O-ring and special silicon grease are consumable
articles. If you run out of the spares, please purchase them.
• The battery gradually depletes even in a storage condition since
the Battery Module incorporates a control PCB. Note that it is not
malfunction. It is recommended to recharge the battery before use.
To protect the O-ring and O-ring applying surface from
dust and dirt, as well as to prevent scratches during
transportation before and after use and during storage, it is
recommended to attach the Battery Module cap (RGB-CAP1)
and Light Module cap (RGB-CAP2).
48