RFNet Wireless LAN Access Point AP-I002
2.3.4 Closing the Front Cover
1) Gently put back the top cover.
2) Using two hands to align the two latches to the grids (See Figure 2-4 on the previous page) on
the left and right top of the unit.
3) Tightening the Screw 1 and 2 (See Figure 2-3 on the previous page).
2.3.5 Mount the AP-I002 (in case of wall mounting)
Should you need wall mounting, please follow procedures listed below:
1) Place the wall mounting guide provided to the location where the device to be mounted.
2) Drill according to the marks.
3) Place the unit to the wall, align the screw hole of your unit to the wall screw hole created
earlier, mount the screw one by one to ensure perfect alignment.
Note:
We recommend you to do the wall mounting before you install the DC Power cord and Ethernet
cable.
Your hardware installation is now completed.
2.4 Power-up the Device
To power-up the AP-I002, connect the device to an AC wall-outlet with the provided AC/DC power
cord.
Warning:
Please use AC/DC power adapters specified in AP-I002 standard package list only.
Power-up sequence (can be observed by LED indicator):
1) 1 second after power-up: LNK LED (Amber) flashes.
2) 30 seconds after power-up: LAN1 or LAN2 (Green) flashes.
When these are finished, the AP-I002 is functional and start bridging operation characterized by the
LED activity as listed in Table 2-1 as follows.
LED Definition
Activity
Description
Power (PWR)
Red
Power Enabled
Ethernet LAN Activity
(LNK)
Flicker Amber
Ethernet LAN Activity
User Manual
11
