5
GETTING STARTED
AP1001G CONFIGURATION
Web Configuration
AP1001g can be configure using a web server.
1. Connect the network as shown previously.
If you are accessing the web server via Ethernet cable, check that the
upper LED lights up on AP1001g.
If your PC is
wireless
, check the PC’s card utility to make sure that the
signal strength is good and that the bottom LED lights up on AP1001g.
2. Open a Web browser (Internet Explorer, Netscape etc.).
3. Type AP1001g LAN IP (
192.168.1.20
) address into the browser’s Address field. The
default LAN IP address of AP1001g is 192.168.1.20.
4. Enter username and password. There are two types of users, admin user and super user.
The default username and password for admin user is admin/admin and the default
username and password for super user is super/super. Only super user will be able to
carry out firmware upgrade.
In every AP1001g Web Configuration page, the left panel is the navigation menu containing the
main sections. The right-side frame is where the detailed configuration is done.
Configuration
panel
Navigation
panel
