3. Safety Instructions
Keep Away from Live Circuits
Operating personnel should
never
remove covers. Component replacement and internal
adjustments must be done by qualified RFL service personnel only.
Do not Operate in an Explosive Atmosphere or in Wet or Damp Areas
!
Do not operate the product in the presence of flammable gases or fumes, or in any area that is wet
or damp. Operating any electrical equipment under these conditions can result in a definite safety
hazard.
Do not Substitute Parts or Modify Equipment
!
There are no serviceable parts in the RFL3200 UK-10, do not install substitute parts or make
unauthorized modifications to the equipment. The product may be returned to RFL for service and
repair, to ensure that all safety features are maintained.
Read the User Guide
!
Operators should read this User Guide before attempting to use the equipment, to learn how to use
the equipment properly and safely.
Throughout this User Guide, warnings appear before procedures that are potentially dangerous, and
cautions appear before procedures that may result in equipment damage if not performed properly.
The instructions contained in these warnings and cautions must be followed exactly.
Warning!
Follow all of your company’s policies and procedures regarding the installation of AC powered or
DC powered equipment. If there is a conflict between any procedure in this manual and your
company’s safety rules, then your company’s safety rules must take priority.
Warning!
For DC operations and AC operations where neutral cannot be reliably identified, readily
accessible double pole disconnects and overcurrent devices must be installed between the building
wiring and the RFL3200 UK-10.
For AC operations where the neutral can be reliably identified, readily accessible single pole
disconnects and overcurrent devices must be installed between the building wiring and the
RFL3200 UK-10.
RFL3200 UK-10 User Guide
RFL Electronics Inc.
October 6, 2010
4
973.334.3100
