Front View
Antenna
Connector
Power
Connector
Power
LED
Communications
LED
Operating Instructions
1.
Place two (2) AA batteries in the transmitter. The LED on top will flash red a few times. Once this
stops, pressing any button on the transmitter will cause the LED on top to rapidly flash green.
2.
Plug the YellowJacket Pro receiver power adapter into a powered outlet, then into the
YellowJacket Pro receiver. The Power LED (red) should now be lit.
3.
After a few seconds the Communications LED should flash green three (3) times. If it flashes any
other number of times, then the mode is wrong. Please contact RFHero Support to quickly and
easily resolve this.
4.
Pressing a button on the transmitter will cause the LED on the top of the transmitter to flash green
to indicate that the signal has been sent.
5.
The Communications LED on the receiver will flash green/red (may appear orange) to indicate that
a valid message has been received from the transmitter. You may also be able to hear the relay
click inside the receiver. If the lid is removed from the receiver, you will also see the relay’s LED
turn on and off as the transmitter’s buttons are pressed.
6.
If the Communications LED flashes red only, the transmitter is not paired with this receiver.
Please follow the directions on the next page titled, “Pairing the YellowJacket Pro Receiver and
Transmitter”.
7.
Your system is now operational and ready for use!
YellowJacket Pro Receiver
Top View
Learn
Button
Fuse Tester
(w/Spare Fuse)
Fuse Tester
LED
Relay 1 LED
Relay 2 LED
Relay 1
Fuse
Relay 2
Fuse
Relay 1
Relay 2
