R.F. Technologies, Inc. • 10
Panasonic Attune II (450 Headset)
1.
Gently push in and pull down to remove cover and expose wires.
2.
Feed audio cable behind center module.
3.
Locate “AUX SP (8Ω) CLASS 2 WIRING.”
4.
Using the small, flathead screwdriver, secure red wire into positive (+) terminal.
5.
Using the small, flathead screwdriver, secure black wire into negative (-) terminal.
6.
Replace cover.
7.
Press wrench icon.
8.
Enter passcode: 12345
9.
Press “lane.”
10. Press “AUX Speaker.”
11. Ensure that Outside MIC is “ON” and volume level set to 15.
12. Ensure that Headset TALK is “ON” and volume level set to 15.
13. Ensure that Beep is “ON” and volume level set to 15.
RFT IS A FAMILY-OWNED, INDEPENDENT MANUFACTURER OF AFTERMARKET PARTS AND IS NOT AFFILIATED WITH
OR ENDORSED BY 3M, NOR ARE RFT PARTS APPROVED BY 3M FOR USE WITH 3M DRIVE-THRU SYSTEMS.
3M 960/1060
1.
Take off cover.
2.
Along right hand side of base station, locate MON SPKR and secure red wire in slot.
3.
Secure black wire in slot directly below labeled COM.
4.
Locate a control knob.
5.
Locate volume control labeled MON INBD.
6.
Rotate control knob clockwise until it doesn’t turn any more.
7.
Locate volume control labeled MON VOLUME.
8.
Rotate control knob clockwise until it doesn’t turn any more, then rotate counter-clockwise
one quarter turn.
9.
Replace cover.
3M XT-1
1.
Remove cover.
2.
Feed audio cable behind center module and through cutout on left hand side.
3.
Under the order point on the lefthand side, locate the two MON positions.
4.
Using the small, flathead screwdriver, secure red wire into top “MON” position.
5.
Using the small, flathead screwdriver, secure black wire into bottom “MON” position.
6.
Replace cover.
7.
Press MODE button once. It should prompt for a passcode on bottom of screen.
8.
Hold down MODE button while pressing 1, 2, 3, 4. Let go of MODE button.
9.
Press MODE button 3 times to get to SYSTEM MENU.
10. Scroll down to “Monitor Volume” and press ENTER.
11. Ensure that Inbound Listen Volume is set to 15 and Enable is “ON.”
12. Ensure that Outbound Listen Volume is set to 15 and Enable is “ON.”
13. Ensure that Vehicle Present Volume is set to 15 and Enable is “ON.”
14. Press MODE button 2 times to get to Main Menu.
Volume may need additional adjustment depending on circumstances unique to each location.
