HORNET 433MHz
DS HORNET-13
Pairing Transmitters to the HORNET-RXM (230Vac version)
Please Note: During Learn and Erase the relays operate at high speed. They should be
isolated from sensitive equipment during this process.
To Pair additional Transmitter buttons to receiver Relay #1
1.
Apply power the receiver and wait 10secs for the unit to enter ‘normal operation’
mode.
2. Switch the receiver unit OFF and then ON again in ~1sec intervals FOUR times final-
ly leaving the unit powered.
3.
The receiver emits a continuous ‘Click’ to confirm it is now in ‘learn’ Mode
4. Press the chosen transmitter button.
5.
The receiver will acknowledge by sounding the a single ’buzz’
6. Learn Process complete.
To Pair additional Transmitter buttons to receiver Relay #2
1.
Apply power the receiver and wait 10secs for the unit to enter ‘normal operation’
mode.
2. Switch the receiver unit OFF and then ON again in ~1sec intervals SIX times finally
leaving the unit powered.
3.
The receiver emits a continuous ‘Click’ to confirm it is now in ‘learn’ Mode
4. Press the chosen transmitter button.
5.
The receiver will acknowledge by sounding the two ’buzzes’
6. Learn Process complete.
Erasing Receivers Memory
1.
Power the receiver unit up and wait 10 seconds for the unit to enter ‘normal opera-
tion’ mode.
2. Switch the unit off and then on again at ~1 second intervals TEN times, leaving the
unit powered.
3.
The receiver confirms Erase cycle complete by giving three short ‘Buzzes’
Configuring Receiver Relays
The jumper links set the outputs to be Momentary (operates as long as transmitter is operated)
or Latching (Relay changes state each time transmitter is pressed).
The jumper links are made/removed by the small link ‘cap’ placed over the pin header.
Link1 controls relay Output #1
Link2 controls relay Output #2
Link FITTED = MOMENTARY
Link OPEN = LATCHING
Image shows,
RLY1 Momentary,
RLY2 Latching.
JUMPER LINKS
LK2 LK1
