HORNETPRO Remote Control
ELITE Receivers
14
x1
+
Individual Button Pairing
Couplage manuel d'un émetteur
Handmatig een zender koppelen
Manuelles Koppeln eines Senders
Emparejamiento manual de un transmisor
Associazione manuale di un trasmettitore
SW1
OP1
HORNETPRO Remote Control
ELITE Receivers
3
Safety Information
Carefully read the following safety information before proceeding with installation, operation, or
maintenance of RF Solutions product. Failure to follow these warnings could result in death or serious
injury
•
This radio system must not be used in areas where there is a risk of explosion.
•
Only qualified personnel should be permitted to access the transmitter and operate the equipment.
•
Always follow operating information as well as all applicable safety procedures and requirements.
•
You must satisfy the age requirements in your country for operating the equipment.
•
Store in a safe place.
•
Keep a clear view of the work area at all time before using, check it is safe to do so
Before maintenance intervention on any remote controlled equipment
•
Do not open the receiver enclosure unless you are qualified.
•
Disconnect all electrical power from the equipment.
•
Check the enclosure and cable for damage regularly, do not use if there is evidence of damage.
Battery Precautions
•
Risk of explosion if battery is replaced with a battery of an incorrect type.
•
Do not short-circuit, disassemble, deform or heat batteries.
•
Never attempt to charge a visibly damaged or frozen battery.
•
Do not use or charge the battery if it appears to be leaking, deformed or damaged in any way.
•
Immediately discontinue use of the battery if, while using, charging, or storing the battery, the
battery emits an unusual smell, feels hot, changes color, changes shape, or appears abnormal in any
other way.
Electrical Safety
ISOLATE the mains electricity supply before removing the cover and observe any relevant safety
information.
•
Maintenance to the product that involves removal of the cover should only be carried out by a
competent person or qualified electrician.
•
Ensure adequate protection on the Load circuit
•
Refer to Product Datasheet for MAX operating Load.
•
Product must be installed in accordance with the local country electrical regulations.
•
A current limiting supply must be used in accordance with the datasheet
