REXROTH Fv Series, Инструкция по эксплуатации

Страница: 123 / 222

E1.03
Frequency arrival detection width Factory Default 5.0 %
Setting range
0.0 % − 20.0 %（of 'maximum
frequency' [b1.05]）
Minimum unit 0.1 %
Used to detect the difference between the output frequency and the set fre‐
quency.
If parameters [E1.00] − [E1.02] are set to ‘4: Frequency/speed arrival signal’,
the difference between the output frequency and the set frequency is within
the setting range, and the output indicating signals are shown in fig. 7-45
"Frequency arrival signal" on page 121 .
Fig.7-45: Frequency arrival signal
E1.04
Frequency detection level FDT1 Factory Default 90.0 %
Setting range
0.0 % − 100.0 %
（of 'maximum frequency'
[b1.05]）
Minimum unit 0.1 %
E1.05
Frequency detection level FDT1 width Factory Default 5.0 %
Setting range
0.0 % − 100.0 %
（of 'maximum frequency'
[b1.05]）
Minimum unit 0.1 %
E1.06
Frequency detection level FDT2 Factory Default 50.0 %
Setting range
0.0 % − 100.0 %
（of 'maximum frequency'
[b1.05]）
Minimum unit 0.1 %
E1.07
Frequency detection level FDT2 width Factory Default 5.0 %
Setting range
0.0 % − 100.0 %
（of 'maximum frequency'
[b1.05]）
Minimum unit 0.1 %
Used to detect if the output frequency is within the setting range of FDT.
●
If parameters [E1.00] − [E1.02] are set to ‘5: Frequency level detection
signal (FDT1)’ or ‘6: Frequency level detection signal (FDT2)’, and the
converter output frequency is within the corresponding FDT range, the
output indicating signals will be output via the output terminals.
DOK-RCON02-FV*********IB01-EN-P
Rexroth Frequency Converter Fv Bosch Rexroth AG 121/219
Parameter Settings