10/29
Bosch Rexroth Canada ıJune.2016 ı Revision 2.0
3.
Turn on the Conveyor to discharge material
4.
Turn on the Spinner, and adjust to typical spread width
5.
Click on the ‘rpm/width’ to enter the width in mm(Metric) or inch(Imperial)
6.
Press ‘END CAL’ button to finish
7.
The ‘rpm/width’ is refreshed with the calibration result
Note: rpm-max Spinner RPM, width-spread width per rpm(mm/inch)
7 Chute Calibration
1.
Select the Chute tab.
2.
Press L or R button to move the chute left or right and also make sure the
feedback work properly and check if the speed of chute movement is desirable.
The speed of chute for both directions can be adjusted individually. The default
is 60%. It is recommended to set both speed the same.
