During transmitting, the LED on the top of the radio will glow red. Release PTT
button when you have finished talking.
Scan
The advanced scan function of RL-328 allows optionally looking for carrier or carrier with CTCSS or
DCS. Your dealer can program the channels to be scanned on the scan list.
*Normal Scan
allows you to scan all the channels you have listed through PC programming. Press
SCAN button, you will see the channel numbers cycling continuously. When the radio stops on a
“Busy” channel, the SCAN mode will stop and resume after about 5 seconds. If your radio has scanned
a channel on which there is a party you want to talk to, you can directly communicate with the party by
pressing the PTT button. To stop scanning, press SCAN button again.
*
Delete a Nuisance channel
allows you remove temporarily the channels which you don’t want to hear
from the scan list. During scanning, when the radio is locked onto a busy channel, press “ENTER” to
remove this channel from the scan list. It won’t be scanned until the radio is turned on again.
Mode Setting
：
Squelch Level
Press MODE for one time, LCD shows And
then, press UP/DOWN key to increase or decrease squelch level from 0 to 8. 0 means squelch
canceling, 8 means tight squelch. Setting the radio to the tight squelch level, you can avoid unwanted
signals or noise, but you may not receive a weak signal. So, it will be better for you to select the normal
squelch level (default value: 3). Press ENTER to save the setting and get back to operation mode or
press MODE to continue setting.
VOX Sensitivity Level
Press MODE repeatedly (normally twice) till LCD
shows Press UP/DOWN key to adjust VOX sensitivity from 0 to 5: 0 means VOX canceling; 1 means
the most sensitive (for quiet environment); 5 means the least (for noisy environment). Press ENTER to
save the setting and get back to operation mode or press MODE to continue setting.
BEEP while pressing the buttons
Press MODE repeatedly (normally 3 times) till LCD shows
Press UP/DOWN key to
choose turning ON or OFF the button press beep. Press ENTER to save the setting and get back to
operation mode or press MODE to continue setting.
SQL
：
3
VXL
：
3
bP
：
ON
