Rexair AquaMate, Руководство пользователя

Страница: 5 / 8

5
quick-start guide
1. Prepare the carpet…
a. Use the Rainbow and Power Nozzle to vacuum the entire area to be cleaned, making sure there is no
remaining debris on the surface.
b. Empty and rinse the water basin. Do not refill.
2. Prepare the AquaMate…
a. Begin with an empty water basin. Attach the Rainbow and dolly. Attach the hose and wands.
b. Insert the bottom wand with male end into the opening located on top of the AquaMate. Press downward
until button lock clicks.
c. Add one capful of Rainbow AquaMate Concentrate Solution to the AquaMate soap reservoir.
d. Fill the remainder of the AquaMate soap reservoir with cool, clean tap water and secure the cap tightly.
e. Fill the AquaMate water reservoir with cool, clean tap water and secure the cap tightly.
f. Place the AquaMate tank onto the AquaMate until you feel it lock into place.
3. Shampoo…
a. Set the AquaMate switch to the SOAP + WATER position. Turn on the Rainbow to HIGH mode.
b. Squeeze the pistol trigger grip and apply solution to the carpet using slow forward and
backward movements across the floor. Use the handle’s trigger lock switch to keep the brush
roll fully engaged.
4. Rinse…
a. Set the AquaMate switch to the WATER ONLY position.
b. Squeeze the pistol trigger grip and rinse the carpet using slow forward and backward
movements across the floor. Use the handle’s trigger lock switch to keep the brush roll fully
engaged.
5. Extract…
a. Set the AquaMate switch to the EXTRACT position.
b. Extract the remaining water from the carpet using very slow backward movements.
c. For extra dry carpet, go over the entire area a second time.
d. When finished cleaning, empty and rinse the water basin. Allow to dry.
PRIMING THE AQUAMATE
The AquaMate may require priming, which may take approximately 20 seconds. To reduce priming time, several things
can be done:
1. Make sure the water tank is fully seated
2. Turn the valve to the SOAP + WATER position
3. Squeeze and release the handle trigger several times
If the soap reservoir becomes empty while you are operating the AquaMate, and the valve is in the SOAP + WATER
position, no water will be dispensed because air is being sucked through the soap reservoir. When operating the
AquaMate without soap, always fill the soap reservoir with water to prevent loss of prime.