24
Adjusting the colour
Painting the frame
Using the supplied painting
template, the speaker can be
coloured to match its environ-
ment. To do this, you should first
remove the speaker grill and fix
the
painting template
in its
place. Make sure that no spray
mist can penetrate the speaker
housing from the side during
painting.
Painting the speaker grille
You should remove the internal
fleece first, if the grill also is to be
painted. The fleece has an
adhesive surface, which allows
you to put the fleece back in
position once the paint has dried.
If the fleece does not adhere any
more, you can use a standard
spray adhesive.
Disassembling
Hold the speaker in position and
unscrew the four fixing screws
until the head of the screw
protrudes by about 1 mm. The
four rotary tensioners are now
back in the install position and
the speaker can be removed.
Technical hints
Cable lengths
In order to keep the line and treble
loss as low as possible, we re-
commend that you use the
following cable profiles and in
any case, you should use 2-core
wire.
Up to 15 m:
Ø 0.75 mm
2
Up to 30 m:
Ø 1.50 mm
2
Over 30 m:
Ø 2.50 mm
2
Up to 50 ft:
AWG 17
Up to 100 ft:
AWG 14
Over 100 ft:
AWG 12
We advise that you avoid using
cable lengths above 50 metres,
in order to avoid loss of hi-fi
reproduction.
Load capacity
It is possible to operate this
speaker with amplifiers that have
a higher output performance. In
this case however, you must
ensure that the volume is only
turned up to a level where your
ear (usually a reliable measure)
starts to notice an overload.
Your Revox speaker will not be
damaged by a
short-term
overload
, as all four speaker
systems are equipped with self-
resetting overload fuses.
Eng
li
sh
