PATENTED and numerous patents pending
© REVOLUTION ACOUSTICS LTD. All rights reserved
Revolution Acoustics®, SSP6™, Multiducer™ as well as all
graphical trademarks herein are property of Revolution
Acoustics Limited.
Additonnal information, including warranty see:
revolutionacoustics.com
GLASS OR OTHER SMOOTH NON-
POROUS SURFACES
UHB Tape (ultra high bond)
: Make sure the Rev
-
Loc™ is clean and dry. a) Apply UHB tape in the
middle of he Rev-Loc™ and b) burnish it onto the
Rev-Loc™ from the center out so as not to entrap
any air bubbles. Ensure window surface is clean.
Rubbing alcohol is a good cleaning agent prior to
installation. c) Screw Rev- Loc™ onto the SSP6
noting cable down orientation (make small pencil
mark to top of Rev-Loc™), so as to ensure the
speaker wire faces down, and then unscrew SSP6
Multiducer™. Peel tape backing off and
firmly press
Rev-Loc™ onto glass with the pencil mark up as
contact pressure activates the adhesive. Allow glue
to cure ½ hour if able and then screw on the SSP6
Multiducer™ as stated in “Glues” on the previous
page. d) Space the SSP6 Multiducer™ at lease 8”
(20cm) from the glass frame.
DRYWALL (PLASTERBOARD)
Super Glue (cyanoacrylate)
. Choose a quality
brand in a medium to light viscosity cyanoacrylate
(super glue) and apply in a tight zigzag pattern no
further than ¼” (6mm) spacing covering the surface,
and immediately press firmly on to a dust free clean
and dry surface. If placing in a wall stud bay, offset
from the center by 2”. Allow glue to set and then
apply the SSP6 Multiducer™ as stated in “Glues” on
the previous page.
ROUGH SURFACES
5 Minute Epoxy glue or Methacrylate
. Fiberglass
and rougher finished wood and the like surfaces
should be clean, dry and dust free. If applying to
rough fiberglass, sand high points down slightly.
Apply glue to entire bottom surface of Rev-loc™
mounting plate as well as the surface to be glued to
in a thin layer. Apply to surface and twist back and
forth very slightly to squeeze out excess glue and
seat the Rev-Loc™ well. Tape in place, let glue set
and then apply the SSP6 Multiducer™ as stated in
“Glues” on the previous page.
Speaker
Cable
Mark
A
B
C
D
8” (20cm) min
8” (20cm) min
Apply glue
to entire
surface
®
2” (5cm) minimum offset from center
Plaster drywall
cavity