Revo RCPTS700-1, Инструкция по эксплуатации

Страница: 5 / 12

5
12.
5. RS-485 Address, Protocol, and Baud Rate Setting.
Address (ID) setting:
Set DIP switches 1 (least significant bit) through 8 (most significant
bit) to set the RS-485 address of the camera. The address can be
set from 0 through 255, and must be matched to the RS-485
address (often calle
d the “ID”) in use by the controlling DVR or
joystick keyboard.
Once set, the camera’s address does not need
to be changed. If more than one RS-485 device is connected using
the same RS-485 wiring, make sure that each device has a different
address.
A
switch in the “up” (or “ON”) position is set to 1.
A switch in the “down” (or “OFF”) position is set to 0.
Note that some DVRs or joystick keyboards may not support an
address of 0 (00000000 on DIP switches).
The address is interpreted by the camera as reversed binary, such
that address 1 would be set as 10000000, and address 128 would
be set as 00000001. The first several RS-485 addresses are as
follows:
DIP Switch Address DIP Switch Address DIP Switch Address DIP Switch Address
00000000 0 11110000 15 01111000 30 10110100 45
10000000 1 00001000 16 11111000 31 01110100 46
01000000 2 10001000 17 00000100 32 11110100 47
11000000 3 01001000 18 10000100 33 00001100 48
00100000 4 11001000 19 01000100 34 10001100 49
10100000 5 00101000 20 11000100 35 01001100 50
01100000 6 10101000 21 00100100 36 11001100 51
11100000 7 01101000 22 10100100 37 00101100 52
00010000 8 11101000 23 01100100 38 10101100 53
10010000 9 00011000 24 11100100 39 01101100 54
01010000 10 10011000 25 00010100 40 11101100 55
11010000 11 01011000 26 10010100 41 00011100 56
00110000 12 11011000 27 01010100 42 10011100 57
10110000 13 00111000 28 11010100 43 01011100 58
01110000 14 10111000 29 00110100 44 11011100 59