REVIER MANAGER RM3, Руководство пользователя

Страница: 25 / 36

25
English
5. INITIAL START-UP OF THE CAMERA
Please check before the intial start-up of the camera, if the SD card has been inserted
properly. It must click into place.
Slide the switch inside the wildlife camera to
SETUP
. After a few seconds the signal
strength symbol will appear on the screen (see page 7 DISPLAY). After 20-30 seconds, the
network operator should appear on the screen (e.g. „Vodafone“ etc.).
Please note
: At least 2 bars should be displayed for the signal strength. Otherwise,
please change location (additional accessories available for better signal strength). The
camera measures the signal strength again when switching on
SETUP and shows this
on the display.
Tip:
On
SETUP
you can check to see how the motion sensor works. The red LED on the
front of the camera only flashes when movement is registered. This can also be used for
optimal alignment and positioning of the camera. When there is sufficient battery power and
signal strength, slide the switch to
ON
.
Attention
: If the signal strength is too weak or the battery performance is too bad, it could
happen that no pictures will be sent to the Reviermanager application.
When using the camera for the first time, check whether the camera triggers a picture
when it moves. As soon as the camera is switched to
ON , the red LED flashes slowly for
10-15 seconds. After this the camera is active, and triggers a picture if there is movement.
Attention : If you use the camera outdoors, please prevent water from dripping down and
collecting below the camera (like rain oder melted snow).
All further information & videos for the explanation can be found at:
http://www.reviermanager.at/faqs.html