CUSTOMER SERVICE: 800-973-8374
13
Power Base Assembly Instructions
Headboard Bracket Installation
STEP 1
STEP 2
Install the headboard brackets to the power base.
Place one bracket on the left-hand side of the
base and one bracket on the right-hand side of
the base.
1. Use the hand control to raise the head of the
base in order to gain access to the power
base.
2. Bolt the Leg Clamp Bracket (A) to the leg
using the headboard bracket bolts (D), and
the 5/16” lock nut (G).
3. Bolt the inner Headboard Bracket (B) to the
Leg Clamp Bracket (A) using the Headboard
Bracket Bolts (E), the 5/16” washer (F), and
the 5/16” lock nut (G).
4. Place the open side of the outer headboard
bracket (C) onto the exposed square tube of
the inner head board bracket (B). This will
Headboard Bracket Bolt (E) with a 5/16 Inch
Washer (F) through the Outer Headboard
Bracket (C) and into the Inner Headboard
Bracket (B). Use a 5/16 Inch Washer (F) and
5/16 Inch Locking Nut (G) and hand tighten to
allow for adjustment. Repeat same procedure
for opposing side of the power base.
5. Ensure the headboard bracket is assembled
a distance of 1.5 (38.1 mm) to 2 inches
(50.8 mm) between the edge of the
power base and the headboard bracket
assemblies.
6. Firmly tighten the headboard bolts (not
included) to the end of the headboard
bracket assembly.
7. Measure the distance of the center to center
mounting holes in the headboard.
8. Measure the distance of the center to center
mounting holes in the headboard bracket
assemblies.
9. If the headboard brackets require
adjustments, loosen the bolts that are
holding the outer headboard brackets and
move them to the necessary distance.
Place your mattress on top of your power base.
Typical
Reverie 4M
™
Power Base
is
Headboard installation
now complete. If the
base is equipped with a programmable setting
or options, refer to the Hand Control Guide for
more information.
G
A
D
I
I
H
D
A G
B
C
E
H
F
F A B
B
A
C
F E
G
E